Gas burner won’t light after getting wet. Gas burners are the main part of a home because you can not cook if something is wrong with it. Therefore, it is very important to keep water away from the burners.
It is because the gas stoves won’t light after getting wet. If you accidentally spoiled water on the stove while cleaning then the first thing to do is switch off the burner and don’t try to use it until it completely dried out.
If you will try to ignite the wet stove then it will begin to click which is not a good thing to happen because it can break the main switch and you will have to pay extra money for its replacement or repair.
You are here it means your stove is also wet and you want its solution so don’t worry this article will surely help you to fix the problem.
- Switch off the gas
- Remove the water from the stove
- Detach the lid
- Leave the stove to dry out completely
- Wait for 24 hours
It is not big trouble that you have to hire some professional. You can also do it with slight effort.
Gas burner won’t light after getting wet
It is very annoying to see your gas burner is not lightning because you cannot cook the meal. If anyone in the home has accidentally spilled water on the stove then you will have to wait for minimum of 24 hours so that it fully dried out.
Some days ago it happened to me so that’s why I am writing this article to tell you what to do in this situation. Keep reading the below-mentioned points.
1. Switch off the gas
The cleanliness of the gas burners is very important to remove the debris from all the components of the unit and also keep the hoses clean so that gas can flow through the pipes to the burner to cook the meal.
In the same way, when you are cooking the meal or cleaning the surface of the burner then do not bring water close to it or drop the water. It is because if the water is spilled on the stove then it will not burn.
- Immediately switch off the gas to decrease the destruction and loss.
- If you are clicking then do not attempt more than three times because it can break the main switch.
- Concentrate on how to remove the water after turning off the gas from the main valve.
2. Remove the water from the stove
After switching off the gas now remove the water from the surface of the stove. You can take a fabric or towel to soak up the all water.
It is very important to clean all the viewable moisture and water from the surface because if you will delay it then the water can damage the other components like the underlying switch etc.
3. Detach the lid
It depends on the quantity of water and how much it can go deeper into the burner. If a small quantity of water like just 1 cup is accidentally fallen on the stove then there will be less water that goes inside the burner and you can just open the lid or cover of the stove to dry it.
If there is a large amount of after fallen on the stove then clean the outer surface completely and open the cover so that water dries out completely.
4. Wait for 24 hours
It is suggested to you don’t try to ignite the burner until the stove is dried out from the outside and inner side. You will have to wait for a minimum of 24 hours so that there should be no wet part in the stove.
After opening the cover of the burner, ensure again that there is no gas leaking from the pipe. Keep watching the stove after some time and if you see any moisture then clean it with a towel.
5. Check the burner after 24 hours
After one day, turn on the gas from the fuel tank or open the main valve of the gas supply. Now ignite the one burner and check that it’s clicking because all the burners should start to burn after the water has been removed completely.
How to fix gas burner that wont light
The final thoughts on this article are to keep the water far away from the stove because if it will fall accidentally on your stove then you will not be able to cook for one day. Do not try to ignite if it is not clicking and wait until all the water dried out.